CADmix II – streamlined powder handling for SLS

CADmix II is a second-generation, 2-in-1 device designed to automate the refreshing and mixing of SLS powders. It replaces multiple manual steps — such as sieving, hand mixing, and shaking — with a clean, fast, and fully enclosed process. Using an intuitive touchscreen interface, the operator can start the cycle in seconds. Inside, special buckets with integrated paddles ensure even blending of fresh and used powder, helping users prepare high-quality, homogeneous mixtures for their next print job. Variable rotation control and quiet operation further optimize efficiency and comfort.

CADmix II can save several hours per print cycle by replacing up to three manual operations — sieving, manual mixing, and shaking — with one fully automated process. The powder is refreshed and homogenized in just a few minutes, depending on the type and amount of material. This allows your team to focus on more valuable tasks while ensuring consistent, ready-to-use powder for the next print job.

Yes. CADmix II supports both standard SLS powders and custom mixtures, including blends with recycled material like HP used. The integrated paddles ensure perfect mixing results.

Definitely. With its compact footprint (727×416×567 mm) and quiet operation (up to 40% less noise than the previous version), it fits perfectly into small production setups or office-like environments.

Not at all. The intuitive touchscreen interface makes it easy for anyone to operate. Most users can begin working confidently with minimal training.

Absolutely. The chamber is fully enclosed and equipped with safety sensors that immediately stop operation if the door is opened. It’s designed to meet modern safety standards.

The CADmix II comes with a bucket with shovels, electric cable, and safety gloves — everything needed to get started.

Minimal. The system is built for durability and ease of use. Routine cleaning and occasional checks are all that’s required to keep it running efficiently.