Replacement of print bed isolation

Every time you change from a lower melting point material to a higher melting point material you should swap the seal cords. It is a good idea to clean off the powder residues on the walls before performing the insulation swap.

You will need: Sinterit Lisa (PRO) Print Bed Sealing Kit, rubber gloves, a stainless steel probe and a plastic spatula.

1. Turn on the printer and open the lid.
2. Turn the printer off and unplug the power cord.
3. Remove the four screws that hold the print bed plate in place. Be careful not to damage the wires that are attached to the heaters underneath.
4. Using the probe, remove the old seals.
5. Install bottom layer of seal – it consists of four short layers of rope (note, there are two pairs, and one pair s slightly longer than the other).
6. The second layer consists of one long loop. The end should meet near the overflow bin.
7. The third layer consists of one long loop as well. This time the end should meet near the middle of the printer